- Electric drive for high-speed surface-broaching machine
- Transformer circuit impedance calculations
- Induction motor speed-torque-current curves
- Using a genetic algorithm for detection and magnitude determination of turn faults in an induction motor
- Selecting distribution-transformer size
- Motor for atomic reactor rod mechanism drive
- Tank pressure variation in sealed transformers
- The apparent-impedance method of calculating single-phase-motor performance
- Comparison of instantaneous reactive power p–q theory with theory of the current's physical components
- Measurement and effect of contact resistance in spot welding
- Performance of traveling waves in coils and windings
- Application of vacuum-tube oscillators to inductive and dielectric heating in industry
- History and development of the electronic power converter
- Armature leakage reactance of synchronous machines
- Approximating Potier Reactance
- Transformer magnetizing inrush currents
- Closed-loop frequency response of nonlinear systems
- Sudden gas pressure relay for transformers
- Liquid cooling of turboalternators
- Relay protection of tapped transmission lines
- The accuracy of measurements in lumped R-C cable circuits as used in the study of transient heat flow
- Relaying with two pilot wires
- Laplacian transform analysis of circuits with linear lumped parameters
- A new frequency multiplier
- Large electric-arc furnaces — performance and power supply
- Transformers with peaked wavs
- Analysis of series capacitor application problems
- Saturated synchronous reactance
- Basic design principles for A-C electric-power systems in large military aircraft
- Grounding principles and practice I — Fundamental considerations on ground currents
- Analysis of 3-phase inverter with resistive load
- The parallel type “inverter”
- Charging-current limitations in cable lines
- Forces in machine end windings
- A self-checking system of supervisory control
- A turbine-governor performance analyzer
- Impedances seen by relays during power swings with and without faults
- Interconnection of primary lightning arrester ground and grounded neutral or the secondary main
- Steady-state and transient-stability analysis of series capacitors in long transmission lines
- Duty cycles and motor rating
- A 5,000-kva underground substation
- Tertiary windings in autotransformers
- Basic single-line diagrams for substations
- Harmonic-current-restrained relays for differential protection
- Application of capacitors for power-factor improvement of induction motors
- Prolonged inrush currents with parallel transformers affect differential relaying
- The analysis of sampled-data systems
- Special metals in the electrical industry
- Aircraft circuit breakers
- The radio proximity fuse