- Two-Terminal MonolithicIn0.5Ga0.5P/GaAsTandem Solar Cells with a High Conversion Efficiency of Over 30%
- Beam Profile Measurement for Electron Accelerators
- Free Standing Sintered Ceramic Films from Electrophoretic Deposition
- Substrate Current due to Impact Ionization in MOS-FET
- Electrorheological fluids and magnetorheological suspensions
- Pulsed laser module based on a high-power semiconductor laser for the spectral range 1500–1600 nm
- Composite Materials and Measurement of Their Acoustic Properties
- Erratum: “Dye sensitized solar cells with carbon black as counter electrodes”
- Call for papers for a topical issue ofJournal of Optics A: Pure and Applied Opticson High-power semiconductor lasers and systems
- The infrared thermometer in school science: teaching physics with modern technologies
- IOT for Agriculture: Food Quality and Safety
- Amorphization of Interstitial Elements Containing Iron Materials by Mechanical Alloying
- Radio Frequency Plasma in Water
- Analytical Calculation of Subthreshold Slope Increase in Short-Channel MOSFET's by Taking Drift Component into Account
- Nonlinear optical properties of 75TeO 2 –20Nb 2 O 5 –5ZnO glasses doped with CeO 2
- Corrigendum: Strain hardening and micro-deformation behavior in advanced DP and TRIP steels: EBSD examinations and crystal plasticity simulations (2018 Mater. Res. Express 5 126507)
- Medical IoT systems: architecture and security
- Microcomposites based on superconducting cuprates
- Comment on the modified Beer–Lambert law for scattering media
- Significance of Charge Sharing in Causing Threshold Voltage Roll-Off in Highly Doped0.1-µmSi Metal Oxide Semiconductor Field Effect Transistors and its Suppression by Atomic Layer Doping
- Super-Resolution Near-Field Disk with Phase-Change Sn-Doped GeSbTe Mask Layer
- Investigation of Cu2ZnSnS4-Based Thin Film Solar Cells Using Abundant Materials
- Highly efficient electrochemical hydrogen evolution based on nickel diselenide nanowall film
- Testing permanent magnets by Faraday disk method
- Fundamentals of Signal-to-Noise Ratio (SNR)
- Separation of Gas Molecule Using Tetra-n-butyl Ammonium Bromide Semi-Clathrate Hydrate Crystals
- Gas Separation Method Using Tetra-n-butyl Ammonium Bromide Semi-Clathrate Hydrate
- Rolling spool—the question
- Structural, electrical and optical properties of transparent conducting SnO2films: effect of the oxygen flow rate
- Multi-scale modeling of the elastic response of a structural component made from a composite material using the materials knowledge system
- First-Principles Study of Titanium Dioxide: Rutile and Anatase
- Modelling an extreme water–lung interface using a single pencil beam algorithm and the Monte Carlo method
- Lifetime and Degradation Mechanism of Multilayer Ceramic Actuator
- Fabrication of Porous PTCR Thermistors and Their PTCR Effects
- Miscellaneous optical solitons in magneto-optic waveguides associated to the influence of the cross-phase modulation in instability spectra
- Erratum: “Adaptive Trellis Using Interim Maximum-Likelihood Detector Output for a Holographic Storage System”
- Simple photoplethysmography pulse encoding technique for communicating the detection of peripheral arterial disease—a proof of concept study
- Development of Novel Atomization System Based on SAW Streaming
- Lead-Strontium-Telluride Films and Lasers Prepared by Hot-Wall Epitaxy
- Diffusion of Boron in Silicon through Oxide Layer
- Novel Interatomic Potential Energy Function for Si, O Mixed Systems
- Example of the description of dissipative processes in terms of reversible dynamic equations and some comments on the fluctuation-dissipation theorem
- Physical and biological mechanisms of direct plasma interaction with living tissue
- Cation Distributions in Nickel Ferrites
- Effect of Utilizing Hydrogen-Treated Tantalum Anodized Oxidation on Symmetry of Current–Voltage Characteristic of Metal–Insulator–Metal Element
- Stabilization of Ferromagnetic States by Electron Doping in Fe-, Co- or Ni-Doped ZnO
- Standing waves in strings—the answer
- New bis(naphthalic anhydrides) and polyheteroarylenes based on them with improved processability
- INTRAMOLECULAR INTERACTIONS IN POLYMER CHAINS
- Fabrication of Gold Nanodot Array Using Anodic Porous Alumina as an Evaporation Mask