view in publisher's site
- خانه
- لیست مقالات
- چکیده
Prolonged inrush currents with parallel transformers affect differential relaying
It has long been known that transient magnetizing inrush currents, sometimes reaching magnitudes as high as eight times full-load current, may flow in a transformer winding for a period following the moment when it is energized by connecting it to an electric power circuit.1 It has not been generally appreciated, however, that other transformers already connected to the power circuit near the transformer being switched may also have transient magnetizing currents of considerable magnitude at the same time, although they themselves are not switched but remain continuously connected to the power circuit, carrying load. It has not been appreciated, moreover, that with this arrangement the transient periods of the inrush currents may be very long, the currents dying away at a much slower rate than would the inrush current of the transformer being switched if the others were not connected. This paper discusses the cause of these phenomena and describes tests made to investigate their occurrence. The results of a mathematical analysis for the currents in the circuit under various conditions, supporting and extending the test results, are given in the appendix. The amount of resistance in the transmission line circuit connecting the parallel transformers with the generating source is shown both by tests and mathematics to be a determining factor; the magnitude of the inrush current in the already connected transformers increasing to values of over twice full load current as the line resistance increases. Magnetizing inrush currents tend to operate the transformer differential relays, causing the circuit breakers to trip and remove the transformer from service when no fault exists within it. Various means have been devised to prevent the operation of the relays on magnetizing inrush current. This paper discusses the effectiveness of these various means when subjected to the inrush currents occurring with parallel-connected transformers, with particular reference to the harmonic restraint relay described in a recent paper.2
جریان هجومی Prolonged با ترانسفورماتورهای موازی اثر رله دیفرانسیل را تحتتاثیر قرار میدهد.
اخیرا مشخص شدهاست که جریان هجومی magnetizing مغناطیسی، گاهی به بزرگی هشت برابر جریان پر بار، ممکن است در یک سیمپیچ انتقالی برای یک دوره زمانی پس از زمانی که انرژی با اتصال آن به یک مدار الکتریکی انرژی تقویت میشود جریان داشته باشد. با این حال، این ترانسفورماتور دیگر متصل به مدار برق در نزدیکی ترانسفورماتور است و ممکن است جریانهای مغناطیسی گذرا از بزرگی قابلتوجه در همان زمان داشته باشد، اگر چه خودشان تغییر نمیکنند، اما به طور مداوم به مدار برق متصل میشوند و بار را حمل میکنند. علاوه بر این، مورد تقدیر قرار نگرفته است که با این ترتیب، دورههای گذرای جریان هجومی ممکن است بسیار طولانی باشند، جریان در حال مرگ با سرعت بسیار آهستهتر از آن است که جریان هجومی ترانسفورماتور در صورتی که بقیه متصل نیستند، تغییر نکند. این مقاله علت این پدیده را مورد بحث قرار داده و تستهای انجامشده برای بررسی وقوع آنها را توصیف میکند. نتایج حاصل از تحلیل ریاضی جریان در مدار تحت شرایط مختلف، پشتیبانی و گسترش نتایج تست در ضمیمه نشانداده شدهاست. مقدار مقاومت در مدار خط انتقال که ترانسفورماتورهای موازی را با منبع مولد متصل میکند هم توسط آزمایش و هم در ریاضیات نشان داده میشود تا یک فاکتور تعیین شود؛ بزرگی جریان هجومی در ترانسفورماتور متصل شده با مقادیر بیش از دو برابر جریان بار کامل افزایش مییابد چون مقاومت خط افزایش مییابد. جریانهای جریان هجومی تمایل دارند که رله دیفرانسیل ترانسفورماتور را به کار گیرند و موجب breakers مدار برای سفر و خارج کردن ترانسفورماتور از سرویس وقتی که هیچ خطایی در درون آن وجود نداشته باشد. روشهای مختلفی برای جلوگیری از عملیات رله در جریان هجومی مغناطیس سازی ابداع شدهاند. این مقاله به بررسی تاثیر این ابزارهای مختلف زمانی میپردازد که در معرض جریان هجومی با ترانسفورماتورهای موازی هستند، با ارجاع خاص به رله کننده هارمونیک که در یک مقاله اخیر توضیح داده شدهاست. < sup ۲ < / sup >
ترجمه شده با 