- Comparative performance analysis of direct and desiccant assisted evaporative cooling systems using novel candidate materials
- On small-scale liquefaction of natural gas with supersonic separator: Energy and second law analyses
- What opportunities could the COVID-19 outbreak offer for sustainability transitions research on electricity and mobility?
- An experimental optimization study on a tube-in-shell latent heat storage
- Hydrogen storage in a Ni–B nanoalloy-doped three-dimensional graphene material
- Techno‐economic feasibility study of an electric‐thermal coupling integrated energy system for commercial buildings in different latitudes
- An experimental investigation on frosting characteristics of a microchannel outdoor heat exchanger in an air conditioning heat pump system for electric vehicles
- Design and investigation of a partial admission radial 2.5‐kW organic Rankine cycle micro‐turbine
- Li‐ion battery state of health estimation through Gaussian process regression with Thevenin model
- Calculation of Electrical Potential and Dust Particle Charge in a Double Dusty Plasma Device
- Study on critical current of a flexible quasi-isotropic HTS conductor with high engineering current density
- Practical design of ultrasonic spray devices: experimental testing of several atomizer geometries
- An evolution-dependent multi-objective ensemble model of vanishing moment with adversarial auto-encoder for short-term wind speed forecasting in Xinjiang wind farm, China
- Investigations on the hydrolysis step of copper‐chlorine thermochemical cycle for hydrogen production
- Performance characteristics of a Novel point Absorber-type WEC based on counter-rotating self-adaptable movement mechanism
- A comparative study on the energy flow of a conventional gasoline-powered vehicle and a new dual clutch parallel-series plug-in hybrid electric vehicle under NEDC
- Kontinuierliche messung des kriechens von UO2 unter bestrahlung
- A steam rising model of steam-assisted gravity drainage production for heavy oil reservoirs
- The influence of heat-treatment on the creep strength of the magnesium-zirconium alloy ZA
- Design and Prototype Test Data for a 300 kW Active Magnetic Bearings-Supported Turbine Generator for Natural Gas Pressure Letdown
- Radioactivity monitoring in environmental water and air around QNPP
- Experimental and Numerical Investigation On the Influence of Thermally Induced Stress Gradients On Fatigue Life of the Nickel-Base Alloy MAR-M247
- Numerical Investigation of a Mistuned Academic Bladed Disk Dynamics with Blade/Casing Contact
- Impact of boundary layer simulation on predicting radioactive pollutant dispersion: a case study for HANARO Research Reactor using the WRF-MMIF-CALPUFF modeling system
- Access Control Design and Implementations in the ATLAS Experiment
- Design of air-cooled waste heat removal system with string type direct contact heat exchanger and investigation of oil film instability
- Computational study of geothermal thermoelectric generators with phase change heat exchangers
- Heat transfer during molten corium-concrete interactions
- Transient analysis of solar still in the presence of dye
- Farm‐scale bio‐power‐to‐methane: Comparative analyses of economic and environmental feasibility
- Development of Novel Polycrystalline Ceramic Scintillators
- Design and operation of NEXTEL-1: an experimental loop for continuous corrosion monitoring of structural materials for NET
- A Ceramic Version of the LSO Scintillator
- Implementation of Grey Wolf Optimization (GWO) algorithm to multi-objective loading pattern optimization of a PWR reactor
- Infrared thermography inspection methods applied to the target elements of W7-X divertor
- Energy efficiency and its influencing factors: a case study
- Effect of excess air on the optimization of heating appliances for biomass combustion
- Investigation of the oxidation behavior of a Turkey coal at low temperature by TGA, FTIR and BET analysis
- Innovative passive management of the Station Black-Out accident for VVER1000/V446 NPP and development of its emergency operating procedures
- Thermodynamic stability of LiCrO2(s) from EMF and comparison of stability of compounds
- Performance and cost comparison of different concentrated solar power plants integrated with direct-contact membrane distillation system
- 3D CFD analysis of subcooled flow boiling heat transfer with hypervapotron configurations for ITER first wall designs
- STRUCTure-based URANS simulations of thermal mixing in T-junctions
- Analysis of integration method in multi-heat-source power generation systems based on finite-time thermodynamics
- An equivalent mathematical model for 2D stimulated reservoir volume simulation of hydraulic fracturing in unconventional reservoirs
- Optimal design of a VVER-1000 nuclear reactor core with dual cooled annular fuel based on the reactivity temperature coefficients using Thermal hydraulic and neutronic analysis by implementing the genetic algorithms
- Performance and emission characteristics of biogas used in diesel engine operation
- A solar driven hybrid photovoltaic module/direct contact membrane distillation system for electricity generation and water desalination
- Optimal placement of electric vehicle charging station for unbalanced radial distribution systems
- Analysis of influencing factors of rupture phenomenon of liquid film on the wall of corrugated plate dryer
[ صفحه 1 از 391 ]
بعدی